RadioPRO4 Interface for Select Honda Vehicles with MSCAN

$249.00 RP4-HD11

An all in one radio replacement and SWC interface for select Hondas

  • Not compatible in HR-V equipped with 5" screen
  • 2012-2014 CR-V models equipped with navigation are not compatible as the pin-out is different


RadioPRO4 Interface for Select Honda Vehicles with MSCAN

Installation Instructions

It is VERY important that you use the latest version of Interface Updater. Not doing so may damage the interfaces software. 

Detailed Instructions

  • If this is the first time, download and install "PAC-UP Interface Updater". This will install the necessary software to update the firmware on the RP Interface. This can be found at in the "Download" tab at the very bottom of the firmware list on this page.
  • Download the firmware file to a location on your computer that you can easily find.
  • Open the Interface Updater Program by going to Start >All Programs >AAMP of America > Interface Updater.
  • Connect the PAC-UP to the computer using supplied USB cable. Connect the PAC-UP to the RP Interface.
  • Click the "Connect" button to establish connection between the PAC-UP and the computer. The "Connected" check box will be checked if successful. If unsuccessful, disconnect the PAC-UP from the computer, restart the software, then reconnect the PAC-UP and try again.
  • Select your RP Interface from the "Interface select" pull down menu.
  • Click "Update firmware". The new firmware can be found where you saved it before beginning.
  • Once the files are chosen the update will begin. When successful it will show the text "End Update".

IMPORTANT: It is very important that the second from last digit of the revision number on your module matches the second from last digit of the new firmware file revision number. If your numbers do not match, please contact our tech support department.

  • Firmware Download, Version 5.1.3 (Released on February 13th, 2015)
    Release Notes
    • Adds Alpine VR command
  • Utility/Other, Version 2.6 (Released on July 21st, 2017)
    Release Notes
    PAC-UP Interface Updater

An all-in-one radio replacement and SWC interface, the innovative RadioPRO4 comes pre-loaded with amplifier retention and SWC software, navigation-based output signals, and other features that save time and money during installation.

  • Retains steering wheel controls (pre-programmed)
  • Data controlled accessory and navigation outputs
  • Retains factory amplifier
  • Retains ability to set the factory clock

Patent # 8,014,540 & 8,184,825

RP4-HD11 Instruction Manual
Rev 3
 Download (760.13k)
RP4-HD11 Tech Brief
Needs to be followed in vehicles that have factory navigation radios.
 Download (467.31k)